Temank PWM MPPT 60A 800W Solar Charge Controller L60

Temank Solar Charge Controller L60 Feature

• Brand: Temank
• Product Model: L60
• Type: PWM/MPPT
• LCD screen display
• Battery reverse discharge protection
• Simple(and more time control)operation
• Battery reverse polarity protection
• PWM charging mode+MPPT
• Battery under voltage protection
• Parameter user can reset
• Overload,short-circuit protection
• A key to open and close the load
• Automatci Temperature compensation function
• A key to restore the factory setting
• USB 5V charge(current 1500mA/1.5A)optional

Temank Solar Charge Controller L60 Specification

Temank Solar Charge Controller L60 Installation

1. Ready Qi installation tools and materials,and cable.Please matching suitable cable
2. Ensure that the current desity<4A/mm2 That will help reduce the line pressure drop.check the installation site meets the relevant safety requirements,avoid damp,dusty,flammable,explosive and corrosive gases
3. Install the controller fixed to the vertical plane,see Section V mounting aperture and hole spacing.In order to ensure a good controller cooling conditions,the controller on the bottom of each reserved 10cm space
4. As shown on the right wiring sequense:load,battery,solar Battery plate is connected to the controller to be taken to ensure that the load,battery,The polarity of the solar cell panel and controller
5. Before use:external temperature sensor probe into the left of the controller temperature probe interface probe placed in similar battery temperature.(Line extensive must be build-in devices of the external temperature probe coextensive Otherwise,the controller will control parameters of the temperature compensation of the error
6. Warning:In order to prevent accidents from occurring,install:non-professionals can not be engaged in loading and unloading operations
7. Charging Problem Solution:
   a.No proper installation of solar panels cable polarity(“+””-”) Removing the polarity,you can re-install the correct
   b.More than the rated power of solar panels to reduce solar panel power does not exceed the rated power controller discharge Problem Solution
   c.Removing the load is not properly connected to the load,re-install the correct
   d.More than the rated load power to reduce load power,the controller does not exceed the rated power
   e.Instantaneous starting current is too large,the battery capacity is too small,the replacement of high-capacity batteries,button troubleshooting
   Wire Cable polarity loose or too square and increase retightening bold cable
   All keys can troubleshoot faults,press 5 seconds to restore factory settings.

If you want to get more information about Temank PWM MPPT 60A 800W Solar Charge Controller L60, please download the manual as below:

Temank PWM MPPT 60A 800W Solar Charge Controller L60 manual