- Brand: Temank
- Product Model: M30
- Charge Model: PWM/MPPT
- LCD screen display
- Easy operation interface
- MPPT+ PWM charging mode
- Parameter user can reset
- A key to open and close the load
- A key to restore the factory settings
- Battery reverse discharge protection
- Battery reverse polarity protection
- Battery under voltage protection
- Overload, short-circuit protection
- Automatic temperature compensation function
- USB 5V charging (for 500mA) for mobile phone
Parameter table
|
Parameters / Model |
MPPT10 |
MPPT20 |
MPPT30 |
MPPT40 |
|
Maximum power current |
12A |
20A |
30A |
40A |
|
Installation Line（mm2） |
4mm2 |
8mm2 |
10mm2 |
12mm2 |
|
Installation Line(AWG) |
10(AWG) |
8(AWG) |
7(AWG) |
6(AWG) |
|
Weight |
280g |
300g |
475g |
480 |
|
Dimensions |
143×89×46（mm） |
187*97*61（mm） |
||
|
System load loss |
≤13mA |
|||
|
Loop Buck |
≤100mV |
|||
|
Battery float voltage |
13.8V（12V system）/27.6V（24V system） |
|
Battery （under voltage) protection |
10.6V（12V system）/21.2V（24V system） |
|
Battery （under voltage) recovery voltage |
12.6V（12V system）/25.2V（24V system） |
|
Charge mode |
MPPT+PWM MODE |
|
Operating Temperature |
-10℃~60℃ |
|
Storage Temperature |
-30℃~70℃ |
|
Humidity requirements |
≤90％, No condensation |
|
Temperature compensation |
-4mV/Cell/℃ |
|
Temperature Probe (built components) |
NTC 100K thermistats |
|
Maximum open circuit voltage of the solar panel |
18V-24V（12V system）36V-48V（24V system） |
|
Solar panels maximum open circuit voltage (V) |
≤48V |
Installation
Note: Installing wires, first loosen the screw counterclockwise
- Ready Qi installation tools and materials, and cable. Please matching suitable cable
- ensure that the current density <4A/mm2 This will help reduce the line pressure drop.
Check the installation site meets the relevant safety requirements, avoid damp, dusty, flammable, explosive and corrosive gases - Install the controller fixed to the vertical plane, see Section V mounting aperture and hole spacing. In order to ensure a good controller cooling conditions, the controller on the bottom of each reserved 10cm space
- As shown on the right wiring sequence: load, battery, solar Battery plate is connected to the controller to be taken to ensure that the load, battery. The polarity of the solar cell panel and controller
- Before use: external temperature sensor probe into the left of the controller temperature probe interface probe placed in similar battery temperature. (Line extension must be built-in devices of the external temperature probe coextensive Otherwise, the controller will control parameters of the temperature compensation of the error
- Warning: In order to prevent accidents from occurring, install: non-professionals can not be engaged in loading and unloading operations
There is detail information about Temank PWM MPPT Solar Charge Controller M30 30A AWG7 At Factory Price as belew:
Temank PWM MPPT Solar Charge Controller M30 30A AWG7 At Factory Price download